Imperial Japanese Japan WW2 Navy NCO Proficiency Badge

Imperial Japanese Japan WWII Army Officers NCO type 95 Sword Katana, Ser.#36512 Full Length 38 inch Blade length 26.25 inch

Imperial Japanese Japanese WWII Army Officers NCO type 95 Sword Katana, Ser.#127325 Full Length 38 inch Blade length 26.25 inch

Japanese Imperial Navy Rising Sun Cotton Flag. Approximate size of the flag is 34 x 54 inches. Rope only on one corner. Condition of the flag show signs of wear with red bleeding stains on the top mid

Japanese National Imperial Navy Rising Sun Silk Flag. Approximate size of the flag is 24 x 36 inches. Rope on both corners. Condition of the flag show signs of wear with small holes throughout. Good e

WW2 Japan Saburo Sakai (1916 2000) was a Japanese naval aviator and fighter ace of the Imperial Japanese Navy during WW2. Sakai had 28 64 aerial victories (including shared) by official Japanese recor

The Pattern 1899 NCO Cavalry Sword Type 32 was used from the Russo-Japan War of 1905 until World War II; this example has the expected crosshatch wood and metal grip, a guard made of standard Japanese

ARTIFACT: WWII Imperial Japanese Aeronautic Association member badge in painted aluminum with bottom half of original case. The Great Japan Aeronautic Association became a member of the Federation Aer

WW2, 5th Air Wing Aleutian Campaign, with original interior and exterior box, die-cast, 1/48 scale, new condition

Imperial Japanese WWII Navy Kaigun To Sword Katana with Samurai Blade Full Length 38.5 inch Blade Length 20.5 inch

Imperial Japanese Kai Gunto with signed blade. This 26 inch long blade is signed with a long signature in Ray Skin Scabbard. Full Length 39.5

Kaigunto Navy Sword signed Ichihara Michihiro Imperial Japanese Navy Kaigunto with 25 1/2" long signed blade. Signature reads Ichihara Michihiro. Blade is in good polish with a well defined temper lin

Imperial Japanese WWII NCO Army Officers Sword with Surrender Tag. Low #1412. Full Leather Combat Cover. Full Length: 37.5 inch Blade Length: 27.5 inch Tag 6x2.5

Overall Condition Is Good. Blade Is In Original Polish With No Fatal Flaws. Missing A Couple Of Spacers/Seppa. Guard Is An Early Type With Alternating Colored Metal Sunburst Ray Design. Wood And Leath

This is a WWII era Imperial Japanese Naval officer's dirk with a tapered grip of ray skin with spiral groove and brass wire binding. The brass pommel cap has a raised cherry blossom motif and gilded b

Imperial Japanese WWII Army NCO Officers Leather Sword Knot. Full Length 19 inch

Imperial Japanese WWII Naval Officers Navy Dirk Dagger With Thicker Than Usual Hand Forged Blade. The Scabbard Covered In Ray Skin. Full Length 16.5 Inch Blade Length 8.5 Inches

Imperial Japanese WWII Naval Officers Navy Dirk Dagger with Thicker than Usual Hand Forged Blade. All Fittings are of Gilded Brass . The Scabbard Covered in Ray Skin. Full Length 16.5 inch Blade Lengt

RARE WWII IMPERIAL JAPANESE NAVY OFFICER DAGGER, DIRK Wire wrapped white sharkskin grip. Mum decorated pommel cap, handle fittings and a short brass crossguard. 8 1/4' blade. Brass habiki. Leather sca

RARE WWII IMPERIAL JAPANESE NAVY OFFICER DAGGER, DIRK, TANTO Wire wrapped white sharkskin grip. Mum decorated pommel cap, handle fittings and a short brass crossguard. Brass habiki. Leather scabbard.

RARE Pre WWII LARGE JAPANESE IMPERIAL NAVY OFFICER DAGGER, DIRK Pre-WWII Japanese Imperial Navy officer's dagger. The blade is polished steel, straight, single-edged, with a sharp point at the butt en

A WWII Japanese Imperial Navy Officer Dagger with Scabbard - A WWII era Japanese naval dagger with gilt brass-bound sharkskin scabbard and stingray handle. The handle is adorned with cherry blossoms a

Pre-WWII Japanese Imperial Navy officer's dagger. The blade is polished steel, straight, single-edged, with a sharp point at the butt end. The heel is covered with traditional habaki. The handle is co

Roughly 3ft x 2ft

NNJ216 Naval Navigation Computer. Wraps around leg.